Keithley S530 Manual page 99

S530/S540 KTE Linear Parametric Test Library (LPTLib) User's Manual
Modifiers that affect source-measure unit (SMU) behavior
Modifier
KI_AVGMODE
KI_HIGHC_MODE
KI_IMTR
KI_INTGPLC
KI_LIM_INDCTR
KI_LIM_MODE
S530-900-01 Rev. E / September 2017
Value
26xx:
KI_INTEGRATE
KI_MEASX
26xx: 0 or 1
KI_S400
KI_DMM
KI_ELECTROMETER
CMTR: 0.006 to 10.002
24xx: 0.01 to 10 (S530 only)
26xx: 0.001 to 25
Any
KI_INDICATOR
KI_VALUE
Section 3: LPTLib command reference
Comment
Controls the behavior of the
avgX command call.
KI_INTEGRATE replaces the
avgX command with the intgX
command.
KI_MEASX replaces the avgX
command with the measX
command.
0 = Disable High C mode
1 = Enable High C mode
Sets up a source-measure unit
(SMU) as a current meter. The
ranges used are representative
of the type of instrument being
simulated. Note that this
setmode turns on the source.
Sets a SMU to use ranges
equivalent to the S400.
Sets a SMU to use ranges
equivalent to a DMM. Provides a
lower resolution, fast
measurement. Used for
high-current applications.
Sets a SMU to use ranges
equivalent to an electrometer.
Provides the best measurement
resolution but slower
measurement time. Used for
low-current applications.
Defines a period in terms of AC
line cycles over which
measurements are averaged.
Controls what measure value is
returned if the SMU is at its
programmed limit. The devint
command default is
SOURCE_LIMIT (7.0e22).
Note that the SMU always
returns INST_OVERRANGE
(7.0e22) if it is on a fixed range
that is too low for the signal
being measured.
Controls whether the SMU
returns an indicator value when
in limit or overrange, or the
actual value measured. The
default mode after a devint
command is to return a value.
3-77