Error Messages; Lpt_Nocomchan - Keithley S530 Manual

Section 4: Error definitions

Error messages

This section lists all of the error messages. The error number, error description, and additional
remarks are given for each error. Note that Linear Parametric Test Library (LPTLib) commands return
negative values, but the messages indicate them as positive values.

3 LPT_NOCOMCHAN

Message: **This is a host-side only error. No message will be generated by the tester.
Remarks: Linear Parametric Test Library (LPTLib) calls may only be sent after a successful call to
the tstsel command. Make sure the tstsel command is called before any other LPTLib
command.
5 SYS_MEM_ALLOC_ERR
Message: Memory allocation failure.
Remarks: The tester does not have enough memory for the Keithley system software to run correctly.
20 LPT_PREVERR
Message: Command not executed because a previous error was encountered.
Remarks: There was an error encountered during a test sequence. All Linear Parametric Test Library
(LPTLib) commands after that point will generate this error. Correct the problem in the test sequence
causing the first error.
21 LPT_FATAL
Message: Tester is in a fatal error state.
Remarks: The tester is in a state requiring user attention. Correct the problem requiring attention.
22 LPT_FATALINTEST
Message: Fatal condition detected while in testing state.
Remarks: The tester entered a fatal state while a test sequence was in progress. Results generated
during this test sequence may not be valid.
24 LPT_TOMANYARGS
Message: Too many arguments.
Remarks: A Linear Parametric Test Library (LPTLib) command has passed more arguments than it
can handle. Reduce the number of arguments by trying to split the call into two or more smaller calls.
4-2
S530/S540 KTE Linear Parametric Test Library (LPTLib) User's Manual
S530-900-01 Rev. E / September 2017