Matrix Commands; Range Commands; Source Commands; Measure Commands - Keithley S530 Manual

S530/S540 KTE Linear Parametric Test Library (LPTLib) User's Manual

Matrix commands

Command
addcon (on page 3-7)
clrcon (on page 3-17)
conpin (on page 3-21)
conpth (on page 3-22)
delcon (on page 3-25)
scp_close (on page 3-65)
tstsel (on page 3-94)

Range commands

Command
lorangeX (on page 3-42)
rangeX (on page 3-60)
setauto (on page 3-74)

Source commands

Command
forceX (on page 3-29)
limitX (on page 3-41)
pulseX (on page 3-57)

Measure commands

Command
avgX (on page 3-11)
bmeasX (on page 3-13)
intgX (on page 3-34)
measX (on page 3-45)
refctrl (on page 3-62)
setXmtr (on page 3-81)
ssmeasX (on page 3-86)
S530-900-01 Rev. E / September 2017
Description
Add a connection.
Clear all connections.
Connect a pin or instrument terminal.
Connect path.
Delete connection.
Disconnect communications to the scope card.
Select test station.
Description
Define lowest range an instrument should use during
autorange operation (i, v).
Put a measuring instrument on a specific range (c, i, v).
Re-enable autorange mode.
Description
Limit an instrument to a set voltage or current other than the
instrument default.
Set the width of a pulse.
Description
Averages measurements of voltage, current, conductance, or
capacitance.
Block measurement; make a series of readings as quickly as
possible.
Integrates a measurement of voltage, current, conductance,
or capacitance.
Measure a voltage, current, conductance, or capacitance.
Enable or disable automatic reference measurements.
Set the source to operate as a voltmeter or current meter.
Steady state measurement (i, v).
Section 3: LPTLib command reference
3-3