Tstsel - Keithley S530 Manual

Section 3: LPTLib command reference

tstsel

This command enables or disables a test station.
Usage
tstsel(long x);
x
Details
Only one test station can be active at a time.
The tstsel command is normally called at the beginning of a test program. Only one call to the
tstsel command per program is recommended.
Calling a new test station within a test program cancels any previous tstsel calls.
To relinquish control of an individual test station so another station can access the system, call the
tstsel command with a value of zero (0). A new test station must then be selected before any
subsequent test control commands are run.
Attempting to run a test program on an already active test station causes the message "Error:
tstsel failed with status = -653. Exiting" to be displayed.
The tstsel command is not required for use in a user test module (UTM).
Also see
None
3-94
S530/S540 KTE Linear Parametric Test Library (LPTLib) User's Manual
The test station number: 1
S530-900-01 Rev. E / September 2017