Table of Contents
Advertisement
3
3-8 Performing Setup from the Control Panel
If you make a mistake during Setup, you can always use the Menu button to
N
:
OTE
cancel without saving changes. If you are viewing a Setup screen, pressing the Menu
button cancels what you are doing in the current screen to bring you to the next
higher-level menu. You may need to press Menu more than once to return to the top
level for the particular Setup procedure with which you are working. Once at the top
level, you can enter the current Setup again, or exit without making changes.
When you have entered the settings, you are prompted to save the changes. If you
choose Yes, your settings overwrite previous settings. If you choose No, your previous
settings are retained. If necessary, the RIP Station reboots after you exit from the Setup
menu.
Server Setup options
The Server Setup menu lets you specify system information that pertains to the
RIP Station itself and all users. Accessing the menu is described on page 3-2.
Exit Setup
Server Setup
Network Setup
Printer Setup
Setup
When you choose Server Setup, the options appear in sequence as described below.
Default values, where applicable, appear in square brackets. Words shown in italics
indicate that a product- or site-specific value is displayed.
Server Name
Default server name
Enter a name for the RIP Station (up to 10 characters long). This is the name that will
appear in the Chooser on an AppleTalk network. Also enter this name when you
configure the connection for the Fiery utilities on IPX/SPX networks (see the Setup
Guide).
Do not use the device name (Pro9000 or Pro7000) as the server name. Also, if
N
:
OTE
you have more than one RIP Station, do not give them the same name.
System Date
Enter the correct system date in the standard form for your usage. The date is used on
the cover page and on Job Logs.
Press button for Server Setup
Advertisement
Table of Contents
