Epson RIP Station 5100 Administrator's Manual page 32

2
2-4 Preparing for RIP Station Setup
Instead of manually assigning the IP address, subnet mask, and gateway address, you
can use DHCP, RARP, or BOOTP protocols to assign some or all of these addresses
(see page 3-15).
The Administrator password controls access to Fiery WebTools. If you do not
specifically set the password, all users have access to all Fiery WebTools functions
(see page 2-1). Using the Administrator password, you can configure WebTool access
by enabling only certain WebTools.
Fiery WebTools include Status, WebSpooler, WebLink, Installer, WebSetup, and Print
Monitor.
Status
The Status WebTool provides users with current information on the jobs processing
and printing on the RIP Station. For more information, see the User Guide.
WebSpooler
WebSpooler allows remote users to preview, manipulate, reorder, reprint, and delete
jobs currently spooling, processing, or printing on the RIP Station. It also allows the
administrator to view, print, or delete the Job Log.
You can control WebSpooler access by setting an Operator password. Only users with
the Operator password can manipulate jobs from Fiery WebSpooler. A user who does
not have the password can still log in to Fiery WebSpooler as a Guest with view-only
access (see page 2-1). For more information, see the User Guide.
WebLink
WebLink provides a link to a pre-set Fiery WebLink destination, which you can
change. To change the destination, see page 5-14. This function requires the
Administrator password, if one has been set. See "Passwords" on page 2-1.
If no Administrator password has been set, any user can set the WebLink
N :
OTE
destination, which affects all users. For this reason, it is strongly recommended that
you set an Administrator password.