Epson RIP Station 5100 Administrator's Manual page 52

3
3-18 Performing Setup from the Control Panel
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
Exit IPX/SPX Setup
Select Frame Types
Clear Frame Types
IPX/SPX Setup
Exit IPX/SPX Setup
Ethernet 802.2 *
Ethernet 802.3
Ethernet II
IPX/SPX Setup
IPX/SPX Setup options
To configure the RIP Station for IPX/SPX protocols, choose IPX/SPX Setup from the
Protocol Setup menu. The RIP Station supports the following frame types for
IPX/SPX—Ethernet 802.2, Ethernet 802.3, Ethernet II, and Ethernet SNAP.
For protocols other than IPX/SPX, the frame type is automatically enabled and does
not require setup, as follows:
With this protocol:
AppleTalk
TCP/IP with Ethernet
Select Frame Types
Enable IPX Auto Frame Type
Yes/No [No]
Specify whether the RIP Station should try to bind to all available frame types. If you
answer No to this option, you can select frame types manually.
You must choose at least one frame type to enable IPX/SPX protocols.
The frame selection screen allows you to make multiple selections. Press the line
selection button beside each frame type used on your IPX/SPX network. An asterisk
(*) appears beside each selected frame type. Press the line selection button again to
deselect a frame type. Use the up and down button to scroll to additional frame types.
The RIP Station binds to each frame type as you select it.
When you have selected all the frame types used, choose Exit IPX/SPX Setup.
Clear Frame Types
You can clear all frame types at once by choosing Exit IPX/SPX Setup, then choosing
IPX/SPX Setup and selecting Clear Frame Types.
And these printing services:
PAP (Printer Access Protocol)
LPD (Line Printer Daemon)
SMB (Windows Printing)
This frame type is
automatically enabled:
Ethernet SNAP
Ethernet II