Port Setup Options - Epson RIP Station 5100 Administrator's Manual

3
3-12 Performing Setup from the Control Panel
8. When you have finished entering protocol settings, choose Exit Protocol Setup and
9. Enter the appropriate settings for the services you will use.
T N
O EXIT ETWORK
1. When you have finished entering service settings, choose Exit Network Setup.
2. Choose Yes when prompted to save changes.
3. From the main Setup menu, choose another Setup or choose Exit Setup.
Exit Port Setup
Ethernet Setup
Parallel Port Setup
Port Setup
Network Setup
Port Setup
then choose Service Setup.
S :
ETUP

Port Setup options

You can enable Ethernet and parallel communication simultaneously. To configure the
RIP Station, choose each port type you use and enter the settings for that port. Since
network setups are nested, the names of higher-level menus are shown in this chapter
to the left of each menu heading.
Ethernet Setup
Enable Ethernet
Yes/No [Yes]
Select Yes if you have Ethernet cabling connected to the RIP Station.
Ethernet Speed
Auto Detect/100 Mbps/10 Mbps AUI/10 Mbps TP [Auto Detect]
Select Auto Detect if your network environment is mixed, or if you do not know the
network speed. If you know the speed of the network to which the RIP Station is
attached (10 Mbps or 100 Mbps), select it.
The options and
10 Mbps TP
either through twisted pair cable on the RJ-45 port or through the AUI port.
refer to how the Ethernet cable is cabled,
10 Mbps AUI