Handling And Safety Instructions; Safety Symbols; Important Safety Instructions - SolarEdge StorEdge Installation Manual

HANDLING AND SAFETY INSTRUCTIONS

During installation, testing and inspection, adherence to all the handling and safety instructions is
mandatory. Failure to do so may result in injury or loss of life and damage to the equipment.

Safety Symbols

The following safety symbols are used in this document. Familiarize yourself with the symbols and their
meaning before installing or operating the system.
WARNING!
Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could
result in injury or loss of life. Do not proceed beyond a warning note until the indicated conditions
are fully understood and met.
CAUTION!
Denotes a hazard. It calls attention to a procedure that, if not correctly performed or adhered to, could
result in damage or destruction of the product. Do not proceed beyond a caution sign until the
indicated conditions are fully understood and met.
NOTE
Denotes additional information about the current subject.
IMPORTANT SAFETY FEATURE
Denotes information about safety issues.
Disposal requirements under the Waste Electrical and Electronic Equipment (WEEE) regulations:
NOTE
Discard this product according to local regulations or send it back to SolarEdge.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING!
The inverter cover must be opened only after shutting off the inverter ON/OFF switch located at the
bottom of the inverter. This disables the DC voltage inside the inverter. Wait five minutes before
opening the cover. Otherwise, there is a risk of electric shock from energy stored in the capacitors.
WARNING!
For StorEdge interface units with an ON/OFF Switch - The ON/OFF switch shuts off the
battery, however does not de-energize the DC lines.
To reduce all components to safe voltage, disconnect all power sources to the system components
prior to any system maintenance procedure:
Disconnect the AC to both the inverter and StorEdge Interface.
l
Turn OFF the inverter ON/OFF switch.
l
Turn OFF the StorEdge Interface ON/OFF switch.
l
SolarEdge-StorEdge Installation Guide MAN-01-00249-1.2
HANDLING AND SAFETY INSTRUCTIONS
3