Connecting The Storedge Interface To The Battery Pack - SolarEdge StorEdge Installation Manual

For smart energy management using the storedge interface

Hide thumbs Also See for StorEdge:

Table of Contents

Connecting the StorEdge Interface to the Battery Pack

Before installing the battery pack according to the instructions p rovided by the battery manufacturer,

connect the battery to the StorEdge Interface as described in this section.

Follow these guidelines:

For easy access to battery connectors, it is recommended to connect the cables to the battery and

to set all the battery DIP switches to their correct positions while the battery is still on the ground.

The following procedure is recommended:

a. Connect all the wires to the battery connection panel

b. Mount the battery

c. Connect to the StorEdge Interface.

Measure the necessary length between the StorEdge Interface and the battery for all cables.

Tie and wrap the cables t o avoid pulling them out during mounting.

Be sure to adhere to all safety cautions and information in the battery documentation.

SolarEdge-StorEdge Installation Guide MAN-01-00249-1.2

Table of Contents