Starting-Up The System - SolarEdge StorEdge Installation Manual

Starting-up the System

1. Select Max Self-Consume. The Energy Manager screen changes to display the following:
L i m i t
E n e r g y
S e t O p e r a t i o n
S t o r a g e
2. Optionally, set the battery OFF periods as follows:
a. Select Set Operation. A list is displayed, allowing 12 monthly profile setup:
J a n
F e b
M a r
A p r
b. Select a month. A list of options is displayed.
S t a r t
E n d
A l w a y s
A l w a y s
c. Select one of the options:
Select Always OFF to avoid battery usage entirely (for example during winter)
l
Set Start Time and End Time to set battery usage in specific hours and avoid usage during
l
specific hours throughout the month (for example at night). This sets the periods during
which the battery will be in the OFF state.
Select Always ON to use battery at all times for charging/ discharging.
l
Starting-up the System
Upon installation and configuration completion, the power optimizers should be paired to the inverter.
Perform pairing as described in this section.
1. Close the inverter cover as described in its manual.
2. Perform pairing: Press and hold down the inverter LCD button for about 10 seconds. The following
message is displayed:
K e e p
f o r p a i r i n g ,
t o e n t e r
R e m a i n i n g :
Keep holding for 5 seconds until the following is displayed:
P a i r i n g
T u r n
3. Turn the inverter ON/OFF switch to ON within 5 seconds. If you wait longer than 5 seconds the
inverter exits the pairing mode. The following message is displayed indicating that the inverter is
performing the pairing:
P a i r i n g
R e m a i n i n g
22
C o n t r o l < D i s >
C t r l < M S C >
C o n t r o l
< O N >
< O N >
< O N >
< O N >
T i m e < 0 0 : 0 0 >
T i m e < 0 0 : 0 0 >
O N
O F F
h o l d i n g b u t t o n
r e l e a s e
m e n u . . .
3 s e c
S w i t c h T o O n
[ s e c ] : 1 8 0
SolarEdge-StorEdge Installation Guide MAN-01-00249-1.2