Connecting the StorEdge Interface
2. Install the bracket with the semi-circles facing down, as shown below. Verify that the bracket is firmly
attached to the mounting surface.
3. Install the interface: Attach the StorEdge interface back brackets to the mounted bracket using the
four supplied screws. Tighten the screws with a torque of 9 N*m / 6.6 lb*ft.
4. Loosen the 4 Allen screws of the StorEdge Interface and remove the cover.
Connecting the StorEdge Interface
WARNING!
For StorEdge interface units with an ON/OFF Switch - The ON/OFF switch shuts off the
battery, however does not de-energize the DC lines.
To reduce all components to safe voltage, disconnect all power sources to the system components
prior to any system maintenance procedure:
Disconnect the AC to both the inverter and StorEdge Interface.
l
Turn OFF the inverter ON/OFF switch.
l
Turn OFF the StorEdge Interface ON/OFF switch.
l
10
Figure 10: Mounting bracket
Figure 11: The StorEdge Interface
Figure 12: StorEdge Interface connectors
SolarEdge-StorEdge Installation Guide MAN-01-00249-1.2