Chapter 3: Storedge Interface Installation; Unpacking And Identifying The Product; Mounting The Storedge Interface - SolarEdge StorEdge Installation Manual

Chapter 3: StorEdge Interface Installation

Unpacking and Identifying the Product

An identification label with product specifications is attached to each device.
Check the equipment for damage before starting installation: There are no loose parts. All parts are either
mounted or located in the accessory kit. If any damage is found, document the damage, and contact
SolarEdge.

Mounting the StorEdge Interface

1. Determine the StorEdge Interface mounting location, on a wall or pole, as follows:
Minimum distance from the battery: 1.5m (5ft)
l
Maximum distance from the battery: 5m (15 ft)
l
Maximum distance f rom the inverter: 100m (328 ft)
l
Maintain a minimum 20 cm (8") clearance between the S torEdge Interface and other objects.
l
SolarEdge-StorEdge Installation Guide MAN-01-00249-1.2
Figure 8: Product label
Figure 9: StorEdge Interface clearance
Chapter 3: StorEdge Interface Installation
9