Connecting The Storedge Interface To Ac; Connecting The Storedge Interface To The Battery Pack - SolarEdge StorEdge Installation Manual

For smart energy management using the hd-wave inverter and lg chem batteries

Hide thumbs Also See for StorEdge:

Table of Contents

Connecting the StorEdge Interface to AC

NOTE

The AC is used for auxiliary power only and does not carry high power.

Use a three-wire cable with a cross section of 1-2mm

To connect to AC:

1. Turn OFF the AC power source to be connected to the interface.

2. Remove the interface AC sealing gland.

3. Strip off 5/16" (8mm) of the AC cable insulation and expose two line wires and one grounding wire.

4. Insert the wire ends into the AC terminals (L, N), and the grounding terminal according to the labels.

WARNING!

The battery should be powered OFF before and during wiring. Turn OFF:

The auxiliary power supply switch

The circuit breaker switch

Before installing the battery pack according to the instructions p rovided by the battery manufacturer,

connect the battery to the StorEdge Interface as described in this section.

Figure 15: AC and grounding connections

StorEdge Interface Installation Guide MAN-01-00380-1.1

Table of Contents