Configuring The System Settings (Advanced Setup Menu) - Yamaha aventage RX-A3070 Owner's Manual

(When using Wireless Direct)
SSID The SSID of the wireless network
Security Security method
Security Key Security key
IP Address IP address
Subnet Mask Subnet mask
MAC Address (Wi-Fi) MAC address
MusicCast Network The status of the MusicCast network connection
Network Connection "Wireless Direct" indication
■ System
Displays the system information on the unit.
Remote ID The unit's remote control ID setting (p.165)
TV Format The unit's video signal type (p.165)
Speaker Impedance The speaker impedance setting of the unit (p.164)
(Brazil, Asia and General models only)
Tuner Freq. Step
The FM/AM tuning frequency setting of the unit (p.165)
System ID System ID number
Firmware Version The version of firmware installed on the unit
X
If the unit detects a newer firmware over the network,
"Information" and "System" icons, and the corresponding message will be displayed in this screen. You can
update the unit's firmware by pressing ENTER in this screen and following the procedure in "Updating the unit's
firmware via the network" (p.171).
■ Multi Zone
Displays information about Zone2, Zone3 and Zone4.
Input The input source selected for Zone2, Zone3 or Zone4
Volume The volume for Zone2 or Zone3
(mail icon) appears at the upper right of the
Configuring the system settings
(ADVANCED SETUP menu)
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE z.
MAIN ZONE z
STRAIGHT
PROGRAM
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE z to set the unit to standby mode and turn it on again.
The new settings take effect.
163
En