Yamaha aventage RX-A3070 Owner's Manual page 39

■ Connecting front speakers that support bi-amp
connections
When using front speakers that support bi-amp connections, connect them to the FRONT
terminals and EXTRA SP1 terminals.
To enable the bi-amp function, configure the "Power Amp Assign" setting in the "Setup" menu
after connecting the power cable to an AC wall outlet (p.53).
The unit (rear)
SPEAKERS
EXTRA SP2
R L R
SURROUND BACK
R.PRESENCE
SINGLE
ZONE 2/ZONE 3/F.PRESENCE
1
9
4
X
The FRONT terminals and EXTRA SP1 terminals output the same signals.
Caution
Before making bi-amp connections, remove any brackets or cables that connect a woofer with a
tweeter. Refer to the instruction manual of the speakers for details. If you are not making bi-amp
connections, make sure that the brackets or cables are connected before connecting the speaker
cables.
EXTRA SP1
L CENTER R FRONT L R L
F.PRESENCE
ZONE 2/ZONE 3/BI-AMP
2
3
9
5
■ Connecting Zone2/3 speakers
When using Zone2/3 speakers, connect them to the EXTRA SP 1-2 terminals.
To utilize the EXTRA SP 1-2 terminals for Zone2/3 speakers, configure the "Power Amp Assign"
setting in the "Setup" menu after connecting the power cable to an AC wall outlet (p.53).
The unit (rear)
R SURROUND L
1 2
3
4
6 7
Main zone
X
• You can select a zone (Zone2 or Zone3) to be assigned to the EXTRA SP 1-2 jacks in "Power Amp Assign" (p.142)
in the "Setup" menu.
• You can also connect Zone2 and Zone3 speakers using an external amplifier (p.113).
39
En
SPEAKERS
EXTRA SP2
R L R L CENTER R FRONT L R
SURROUND BACK R.PRESENCE F.PRESENCE
SINGLE
ZONE 2/ZONE 3/F.PRESENCE ZONE 2/ZONE 3/BI-AMP
1
5
Zone2 or Zone3
1
Zone2 or Zone3
EXTRA SP1
L
2
2