Machine Speed; Machine Speed & Direction In Which The Machine Pulley Runs; Motor & Belt - KANSAI SPECIAL MZ Series Instructions Manual

【2】MACHINE SPEED
2 2 2 2 - - - - 1 Machine speed & direction in which the ma 1 Machine speed & direction in which the machine pulley runs 1 Machine speed & direction in which the ma 1 Machine speed & direction in which the ma
Refer to the table below for maximum and standard
speeds of the Series. To extend machine life, run
the machine approximately 15~20% below the
maximum speed for the first 200 hours of operation
(approx. 1 month). Then run the machine at the
standard speed.
clockwise as the handwheel does as seen from the
machine pulley.
2 2 2 2 - - - - 2 Motor & belt 2 Motor & belt
2 Motor & belt 2 Motor & belt
Motor : 3-phase, 2-pole, 400W clutch motor
Belt : M type V belt
Select the proper motor pulley according to the
machine speed (refer to the motor pulley outer
diameter on the table below).
position the motor by pressing the finger onto the
middle of the belt so that 1~2cm deflection can be
achieved (see the illustration on the right).
< Machine speed >
Type
MZ1003
MZ1103
< Motor pulley selection table >
Motor pulley
Outer diameter
(mm)
80
90
100
110
The machine pulley turns
Maximum speed Standard speed
4500SPM
4000SPM
Machine speed (SPM)
50Hz 60Hz
3300 3900
3700 4400
4100 4900
4500 (5400)
chine pulley runs chine pulley runs chine pulley runs
Adjust where to
4000SPM
3500SPM
2