Page 1
INSTRUCTION Industrial Sewing Machines First published : January 2002 No. 020002...
Page 2
INTRODUCTION INTRODUCTION INTRODUCTION Thank you for your purchasing Kansai Special's MC30 tape cutter. Read and study this instruction manual carefully before beginning any of the procedures and save it for later use. This instruction manual describes adjustments, handling and maintenance procedures on tape cutter.
【 1】 WIRING 1 1 1 1 - - - - 1 Power Supply Cord 1 Power Supply Cord 1 Power Supply Cord 1 Power Supply Cord Connect electric cord A to ON/OFF switch of machine head. Connect the cords with blue and brown color to 2 of 3 terminal of B, C, D.
【 2】 ADJUSTMENT( ELECTRIC TYPE) 2 2 2 2 - - - - 1 Height of Cutter 1 Height of Cutter 1 Height of Cutter 1 Height of Cutter Loosen screw E and adjust lever F in order to set 24 mm of the distance between lower cutter and upper cutter at the top position (top dead point).
【 3】 AIR PIPING & WIRING ( AIR TYPE ) Connect the air tube and the electric cords with referring to the following picture. (also refer to the parts list.) After connecting, fix the air tube and the electric cords with bands onto the proper place under the table.
【 5】 ADJUSTMENT (AIR TYPE) 5 5 5 5 - - - - 1 Height of Cutter 1 Height of Cutter 1 Height of Cutter 1 Height of Cutter Loosen screw K and adjust lever L in order to set 24 mm of the distance between lower cutter and upper cutter at the top position (top dead point).