Rear Panel Switches And Connectors; Configuration Switches; Configuration Switch Functions - Renishaw PI 200-3 Installation Manual

PI 200-3 installation guide
www.renishaw.com

Rear panel switches and connectors

Configuration switches

All switches are hardware controlled and a change to any switch setting is effective immediately.

Configuration switch functions

Switch number Function
1 HALT polarity
2 Head LED control
3 STOP disabled
4 SYNC polarity
5 Audible indicator
6 Debounce time
7 Debounce mode
8 Zero debounce
9 Probe signal filter
10 Trigger level
11 PDAMP / HALT filter delay
12 PDAMP / HALT filter delay
13 Probe polarity reversal
Switch 1:
Inverts the polarity of the HALT output.
Issued 01 2018
Switch position Description
UP HALT active HIGH
DOWN HALT active LOW
UP External control via PICS
DOWN LED mimics SYNC
UP PI 200-3 ignores PICS - STOP
DOWN STOP asserts HALT/SYNC
UP SYNC HIGH and SSR closes on trigger
DOWN SYNC LOW and SSR opens on trigger
UP No beep on trigger
DOWN Indicator beeps on trigger
Selects SYNC debounce time
Selects SYNC debounce mode
UP Sets debounce time <2 ms
DOWN Debounce set by switches 6 and 7
UP Filter active
DOWN Filter off
UP Trigger level 2 selected
DOWN Trigger level 1 selected
Coded to select delay time
Coded to select delay time
Refer to table 3
UP Reversed
DOWN Normal
16