Connecting To The Ethernet Lan; Connecting To Usb Host Or Hub; Power Up With The Multiport Cable - VeriFone Mx800 Series Installation Manual

Connecting to the
Ethernet LAN
Connecting to USB
Host or Hub
NOTE
Power Up with
the Multiport
Cable
WARNING
x
To connect the M 800 Series terminal to an Ethernet LAN through the 10BaseT
port, using a standard Ethernet cable, insert the LAN cable from the LAN router or
hub into the 10Base-T port on the bottom of the M
Connecting to a USB host or hub requires a VeriFone USB cable (VPN 22982-xx).
To connect to a USB host or hub:
1
Insert the modular plug on the USB cable into the USB jack.
2
Route the cable through the slots to the desired exit side.
3
Plug the other end of the USB cable into the USB host or hub.
x
The M 800 Series series terminal can be connected to an ECR through the USB
cable. When connected through a USB cable, the M
gets power through the USB cable and does not require the multiport cable.
This section describes how to connect the M
source with the multiport cable.
If connected to an ECR, the M
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
1
Make all other connections before connecting the power pack.
2
Insert the multiport cable connector into the port on the back of the M
Series terminal (see
3
Route the cable through the slots to the desired exit side.
4
Plug the power pack into an indoor electrical power outlet
Figure 13 Power Pack Connection
If no application is installed in the terminal, the message DOWNLOAD NEEDED
displays for a moment, then the main M
application-specific prompt displays when an application executes.
x
800 Series terminal to a power
x
800 Series terminal gets power from the ECR.
Figure 13).
x
800 Series terminal screen displays. An

Power Up with the Multiport Cable

x
800 Series terminal.
x
800 Series series terminal
x
(Figure 13).
X
M 800 S I
ERIES NSTALLATION
I
NSTALLATION
800
21
G
UIDE