Connecting the
Device
WARNING
Multiport Cable
Disconnecting
Multiport
Brief descriptions of possible M
power pack connection are provided in this section. For complete information
about installing and using an optional device, refer to the user documentation
supplied with that device. For a list of compatible cables for these connections,
see Accessories.
Before connecting the M
to a power source. Unplug all power packs from the wall jack.
x
The M
800 Series terminal uses a multiport cable
connections, including connections to
•
an ECR,
•
an RS-485 LAN, or
•
a development/host PC.
Ethernet LAN and USB connections are made using the
Modules
option.
Figure 10
Multiport Cable: Front and Rear
The following are the precautions taken at the time of disconnecting the Multiport:
•
Improper installation or removal of the terminal connector may
permanently damage the M
•
Do not force the terminal connector into place.
•
Always make sure all of the pins are lined up in correct parallel fashion
before applying light pressure to snap the terminal connector into place.
•
Do not attempt to remove the terminal connector by pulling directly on the
cable. Instead, firmly grasp the sides of the terminal connector with thumb
and forefinger, then pull straight away at the same angle the connector on
the terminal is facing.
•
Disconnecting the power source during transaction processing may cause
loss of transaction data.
x
800 Series terminal device connections and the
x
800 Series terminal, ensure all units are not connected
x
800 Series.
Connecting the Device
(Figure
10) to make most
Installing Optional
X
M
800 S
I
ERIES
NSTALLATION
I
NSTALLATION
19
G
UIDE