Optional Log Set Placement Instructions - Quadra-Fire CB1200MI-MBK Installation Manual

CB1200 Pellet Insert
Figure 26.1
Figure 26.2
Figure 26.3
Thermostat Operation
Heat (On) or
Back
Off button
light
Figure 26.4
26
Terminal Block
Center 2 Screws for
Thermostat Wires
Power Outlet
W R
Press and pull Press and pull
to remove to remove
Digital display Digital display
Temperature buttons
Press up or down to set
preferred temperature.
H. Optional Log Set Placement Instructions
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
1. Place the front log in first as shown in Figure 26.5
charred area surrounding fire pot.
2. Set the left and right logs onto the front log, placing
the holes in the base of the left and right logs over the
locating pins in the front log. See Figure 26.6. Ensure
that the charred ends are facing the fire pot.
Figure 26.5
Charred Areas in the Back
Top Log, Left
Figure 26.6
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement vari-
ation other than shown here can cause excessive heat
and shall void the appliance warranty.
7014-285A
CAUTION
LOCATING PINS
Top Log
Right
Front Log
October 9, 2017