Table of Contents
Advertisement
CB1200 Pellet Insert
C. Adjustable Hopper Options
Depending on your installation, the hopper can be adjusted
down 2-1/2 inches (64mm) and will decrease in capacity
from 75lbs to 60lbs.
To adjust hopper:
1. Using a Phillips head screwdriver, remove all the
screws from the top of the hopper securing the
top hopper piece to the bottom hopper piece and
insert body.
2. Adjust downward 2-1/2 inches (64mm).
3. Mark location for new holes and drill new holes.
4. Secure hopper pieces together using screws removed
in step one.
5. See drawing on page 8, Figures 8.1 and 8.2.
D. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
1. Place the front log in first as shown in Figure 24.2
charred area surrounding fire pot.
2. Set the left and right logs onto the front log, placing
the holes in the base of the left and right logs over the
locating pins in the front log (See Figure 24.3). Ensure
that the charred ends are facing the fire pot.
LOCATING PINS
Figure 24.2
24
Charred Areas in the Back
Top Log, Left
Figure 24.3
NOTE: Due to the abrasive nature of a pellet appliance
fire, the logs are not covered under warranty.
Any placement variation other than shown here
can cause excessive heat and shall void the
appliance warranty.
7027-804G
Top Log
Right
Front Log
05/21
Advertisement
Table of Contents
