Table of Contents
Advertisement
Quick Links
INSTALLER: Leave this manual with party responsible for use and operation.
OWNER: Retain this manual for future reference.
CASTILE PELLET INSERT
APPLIANCE
MODEL(S):
CASTILEI-MBK-C
CASTILEI-PMH-C
CASTILEI-TWL-C
Check building codes prior to installation.
• Installation MUST comply with local, regional, state
and national codes and regulations.
• Consult local building, fire officials or authorities
having jurisdiction about restrictions, installation
inspection, and permits.
Installation and service of this appliance should be performed by
qualified personnel. Hearth & Home Technologies recommends
HHT Factory Trained or NFI certified professionals.
1
Installation Manual
Installation & Appliance Set-Up
NOTICE: DO NOT DISCARD THIS MANUAL
CAUTION
R
If the information in these instructions is
not followed exactly, a fire could result
causing
injury, or death.
• Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
• Do not over fire - If appliance or chimney connector
glows, you are over firing. Over firing will void
your warranty.
• Comply with all minimum clearances to combustibles
as specified. Failure to comply may cause house fire.
Hot glass will cause burns.
• Do not touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room
as fireplace.
• Alert
children
high temperatures
• High temperatures may ignite clothing or other
flammable materials.
• Keep
clothing,
flammable materials away.
Tested and approved for wood pellets only. Burning of
any other type of fuel voids your warranty.
NOTE: To obtain a French translation of this manual,
please contact your dealer or visit
REMARQUE : Pour obtenir une traduction française de
ce manuel, s'il vous plaît contacter votre revendeur ou
visitez
www.quadrafire.com
7022-801H
WARNING
property
damage,
WARNING
HOT SURFACES!
Glass and other surfaces are hot
during operation AND cool down.
and
adults
to
furniture,
draperies
CAUTION
www.quadrafire.com
personal
hazards
of
and
other
06/21
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Quadra-Fire CASTILEI-MBK-C
Summary of Contents for Quadra-Fire CASTILEI-MBK-C
- Page 1 • Do not store or use gasoline or other flammable vapors MODEL(S): and liquids in the vicinity of this or any other appliance. CASTILEI-MBK-C • Do not over fire - If appliance or chimney connector glows, you are over firing. Over firing will void CASTILEI-PMH-C your warranty.
-
Page 2: Table Of Contents
F. Equivalent Feet of Pipe ..... 17 G. Pipe Selection Chart ..... . . 17 Quadra-Fire is a registered trademark of Hearth & Home Technologies. 7022-801H... -
Page 3: Important Safety Information
CASTILE INSERT Important Safety Information A. Appliance Certification B. BTU & Efficiency Specifications Model Castile Pellet Insert Emissions Report #: 0061PM077E EPA Certification #: 175-19 Laboratory OMNI Test Laboratories, Inc. EPA Certified Emissions: 1.1 grams per hour Safety 061-S-77d-6.2 Report No. *LHV Tested Efficiency: 70.4% Solid Fuel Room Appliance/Pellet Fuel **HHV Tested Efficiency: 66.1%... -
Page 4: Glass Specifications
CASTILE INSERT I. California - Prop65 C. Glass Specifications This appliance is equipped with 5mm ceramic glass. WARNING Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass. This product and the fuels used to operate this product (wood), and the products of combustion of such fuels, can expose you to D. -
Page 5: Getting Started
CASTILE INSERT Install Guide Getting Started A. Design, Installation & Location Since pellet exhaust can contain ash, soot or sparks, you must consider the location of: Considerations • Windows 1. Appliance Location • Air Intakes • Air Conditioner NOTICE: Check building codes prior to installation. •... -
Page 6: Thermostat Wall Control Location
CASTILE INSERT C. Tools And Supplies Needed WARNING Tools and building supplies normally required for installation, unless installing into an existing Risk of Fire! masonry fireplace: • Damaged parts could impair Reciprocating Saw safe operation. Channel Locks • Do NOT install damaged, incomplete or Hammer substitute components. -
Page 7: Install Checklist
CASTILE INSERT E. Install Checklist ATTENTION INSTALLER: Follow this Standard Work Checklist This standard work checklist is to be used by the installer in conjunction with, not instead of, the instructions contained in this installation manual. __________________________________________________________________________ Customer: ______________________________________________________________________ Date Installed: _______________________________________________________________________ Lot/Address: ________________________________________________________________... -
Page 8: Dimensions And Clearances
CASTILE INSERT Dimensions and Clearances A. Appliance Dimensions 27-3/4 in (706mm) 27-3/4 in (706mm) 27-7/8 in (708mm) 27-7/8 in (708mm) 23-3/8 in (594mm) 23-3/8 in (594mm) 23-3/8 in (594mm) 23-3/8 in (594mm) 8 in 8 in 8 in 8 in (203mm) (203mm) (203mm) - Page 9 CASTILE INSERT 21 in 21 in 21 in 21 in 25-1/4 in 25-1/4 in (533mm) (533mm) (533) (533) 25-1/4 in 25-1/4 in (643mm) (643mm) (643) (643) 11-3/8 in 11-3/8 in 11-3/8 in 11-3/8 in (290) (290) (290mm) (290mm) 9-3/4 in 9-3/4 in 2 in (51mm) 2 in (51mm)
-
Page 10: Clearance To Combustibles, Ul And Ulc
CASTILE INSERT B. Clearance To Combustibles, UL and ULC AS A BUILT-IN - Framing Dimensions 23 in - top vent** 23 in - top vent** (584mm) (584mm) 23-1/2 in - rear vent** 23-1/2 in - rear vent** (597mm) (597mm) 31-7/8 in. (810mm) 16-7/8 in.* (429mm) -
Page 11: Masonry Chimney And Fireplace Clearances
CASTILE INSERT C. Masonry Chimney and Fireplace D. Minimum Opening for Masonry & ZC Clearances Fireplaces TOP TRIM 16-1/4 in 16-1/4 in 16-1/4 in 16-1/4 in (413mm) (413mm) (413mm) (413mm) 29-3/4 29-3/4 (1010mm) (1010mm) Figure 11.3 FLOOR PROTECTION Location Inches Millimeters 32-3/8 in (822mm) 32-3/8 in (822mm) -
Page 12: Hearth Extension
CASTILE INSERT E. Hearth Extension WARNING Use a non-combustible ember floor protector, extending beneath the appliance and to the front, and to the sides as THIS FIREPLACE MAY HAVE BEEN ALTERED indicated in Floor Protection below. TO ACCOMMODATE AN INSERT. IT MUST BE RETURNED TO ITS ORIGINAL CONDITION BEFORE USE AS A SOLID FUEL BURNING FIREPLACE. -
Page 13: Installation Into A Masonry Fireplace
CASTILE INSERT I. Prefabricated Metal Chimney Measure and mark the metal floor for cutting. With a drill, make a starter hole in each corner. The chimney can be new or existing, masonry or prefabricated and must meet the following minimum requirements: •... -
Page 14: Vent Information
CASTILE INSERT Vent Information A. Venting Termination Minimum Requirements Electrical Service Inside Corner FIXED FIXED OPEN CLOSED CLOSED OPEN J or K Termination Cap Air Supply Inlet Gas Meter Restricted Area All minimum clearances are listed with an Outside Air Kit (OAK) installed, unless otherwise noted in table below. 12 in. -
Page 15: Avoiding Smoke And Odors
CASTILE INSERT B. Avoiding Smoke and Odors Vent Configurations When installing a pellet appliance with a horizontal vent Negative Pressure, Shut-Down and Electrical Power configuration the frequency of power outages should Failure be considered: • Power outages during operation will cause the To reduce the probability of back-drafting or burn-back appliance to immediately turn off and may create in the pellet appliance during power failure or shut down... -
Page 16: Negative Pressure
2. Mobile Home: Approved for all Listed pellet vent. Causes include: A Quadra-Fire Outside Air Kit must be used with • Exhaust fans (kitchen, bath, etc.) manufactured home installations. • Range hoods •... -
Page 17: Equivalent Feet Of Pipe
CASTILE INSERT F. Equivalent Feet of Pipe WARNING The table below can help you calculate the equivalent feet of pipe which is a method used to determine pellet vent size (Figure 17.1). Vent surfaces get HOT, can cause burns if touched. Non-combustible shielding or guards may be required. -
Page 18: Venting Systems
CASTILE INSERT Venting Systems A. Direct Connect with Outside Air B. Direct Connect without Outside Air NOTE: In Canada, only a full reline is allowed per ULC S628-93, ORD ULC C1482-M1990. NOTE: • Use non-combustible material around exhaust vent pipe and seal all edges with non-flammable insulation such as fiberglass, mineral wool or... -
Page 19: Full Reline With Outside Air - Horizontal
CASTILE INSERT C. Full Reline With Outside Air - Horizontal CAUTION WARNING Fire Risk. Never draw outside combustion air from: Inspection of Chimney: • Wall, floor or ceiling cavity • Masonry chimney must be in • Enclosed space such as an attic or garage good condition. -
Page 20: Full Reline With Outside Air - Vertical
CASTILE INSERT D. Full Reline With Outside Air - Vertical NOTE: In Canada, only a full reline is allowed per ULC NOTE: Check clearances carefully for this type of installation to ensure adequate room for outside S628-93, ORD ULC C1482-M1990. air venting. -
Page 21: Appliance Set-Up
CASTILE INSERT Appliance Set-Up D. Outside Air Kit Instructions A. Leveling System 1. Measure distance from floor to air vent opening in The leveling bolts are located at the rear of the appliance. appliance and mark location on wall. To access the bolts, remove the side access panels. 2. -
Page 22: Surround & Trim Set
CASTILE INSERT E. Surround & Trim Set 1. Lay surround face down on a flat protected surface to prevent scratching. Back of Top Panel 2. Using the Phillips head screwdriver attach the side surrounds to the top surround using 2 sheet metal Screws screws provided with the kit on each side. -
Page 23: Surround And Cast Trim Set
CASTILE INSERT F. Surround and Cast Trim Set 5. Remove the cast sides before attaching the surround and trim. Lift up the top to expose the thumb screws 1. Place the peel and stick round felt vibration insulation that secure the cast sides. Remove the thumb screw pads on the front side in each corner of the top metal and top bracket and then remove the cast side. -
Page 24: Thermostat Installation
CASTILE INSERT G. Thermostat Installation The kit comes with a programmable wall thermostat and 25’ of thermostat wire. If you need to run more than 25’ make sure you use a continuous strand of 18 to 22 gauge thermostat wire. For optimum performance your thermostat should be: •... -
Page 25: Optional Log Set Placement Instructions
CASTILE INSERT H. Optional Log Set Placement Instructions Two Piece Log Set Installation 1. Open door to expose the firebox. 2. Install the left log first and then the right log (Figure 25.1). 3. Lean the logs against the cast iron brick in the back of the firebox. -
Page 26: Mobile Home Installation
CASTILE INSERT Mobile Home Installation You must use a Quadra-Fire Outside Air Kit for CAUTION installation in a mobile home. 1. An outside air inlet must be provided for the combustion air and must remain clear of leaves, debris, THE STRUCTURAL INTEGRITY OF THE MOBILE ice and/or snow. -
Page 27: Reference Materials
CASTILE INSERT Reference Materials A. Service and Maintenance Log Date of Service Performed By Description of Service 7022-801H 06/21... - Page 28 CASTILE INSERT Date of Service Performed By Description of Service 7022-801H 06/21...
- Page 29 CASTILE INSERT Date of Service Performed By Description of Service 7022-801H 06/21...
- Page 30 CASTILE INSERT Date of Service Performed By Description of Service 7022-801H 06/21...
- Page 31 CASTILE INSERT Date of Service Performed By Description of Service 7022-801H 06/21...
-
Page 32: Accessories
Snap Disc, Manual Reset, L250F ( #3 ) SRV230-1290 Convection Blower, 150 CFM 812-4900 CASTILE INSERT Feed Adjustment Plate SRV7022-119 Matte Black SRV7022-031 B. Accessories Component Pack Assembly (Includes Firepot Cleanout Tool, Touch-Up Paint, Power Cord, Thermostat Wire Twilight SRV7022-032 Castile Insert-C Harness, Owners Manual, Warranty Card, “How-To”... - Page 33 CASTILE INSERT Castile Insert-C Service Parts Beginning Manufacturing Date: Feb 2011 Ending Manufacturing Date: May 2019 IMPORTANT: THIS IS DATED INFORMATION . Parts must be ordered from a dealer or Stocked Hearth and Home Technologies does not sell directly to consumers distributor.
- Page 34 CASTILE INSERT Castile Insert-C Service Parts Beginning Manufacturing Date: Feb 2011 Ending Manufacturing Date: May 2019 IMPORTANT: THIS IS DATED INFORMATION . Parts must be ordered from a dealer or Stocked Hearth and Home Technologies does not sell directly to consumers distributor.
- Page 35 CASTILE INSERT 7022-801H 06/21...
- Page 36 Hearth & Home Technologies 352 Mountain House Road Halifax, PA 17032 Division of HNI INDUSTRIES Please contact your Quadra-Fire dealer with any questions or concerns. For the number of your nearest Quadra-Fire dealer log onto www.quadrafi re.com CAUTION DO NOT DISCARD THIS MANUAL •...
Need help?
Do you have a question about the CASTILEI-MBK-C and is the answer not in the manual?
Questions and answers