Table of Contents
Advertisement
red
8.
CLEANING AND MAINTENANCE
Inspection and maintenance, carried out to the highest standard at
regular intervals and using only genuine parts, are of primary importance
for fault-free operation and long life cycle of the boiler.
Boiler maintenance is compulsory pursuant to the applicable Laws in
force and it must be performed with the frequency set out in Italian
Presidential
amendments regarding the type of fuel used and the boiler output.
Failure to perform Inspections and Maintenance may cause material
damage and personal injury.
For this reason, you are advised to take out an inspection and maintenance contract.
Inspection is necessary to determine the current condition of an appliance and to compare it with the
nominal condition. This is carried out through measurements, checks and observations.
Instructions for inspection and maintenance
8.1.
To ensure the long-term operation of your appliance and avoid altering the
approved standard conditions of the product, only RED genuine spare parts must be
used.
Clean ash deposits from the heat exchange surfaces of the boiler regularly to ensure efficient operation
and high reliability of the appliance.
Ashes deposited on the surfaces of the combustion chamber of the boiler must be removed before
the start-up process (before igniting the fuel) or, if the boiler was not stopped for several days, ashes must
be removed every 2-3 days, according to heat output, fuel consumption rate and wood log properties
(mainly ash content).
Figure 8.1.1 Tools (scraper and brush) for cleaning ashes from heat exchange surfaces of the boiler
Cleaning and maintenance
TECNIKA 28-35
USE AND INSTALLATION MANUAL
Decree
412
of
26
th
August
1993
Technical dept. - All rights reserved - Reproduction prohibited
Chapter
page 47
and
subsequent
8
Advertisement
Table of Contents
