RED TECNIKA 28 Use And Installation Manual page 50

red
The turbolators positioned in the convective section of the boiler can be observed after having loosened the
fastening nuts and removing the upper lid.
Figure 8.1.5 Turbolators installed in convective section of boiler
The ash cleaning procedure must be carried out with a special tool, in particular a metallic brush rubbed
from the top down. After having brushed and removed ash, the collected ash residues must be removed by
opening the lower lid to scrape ashes from the lower section of the boiler convective heat exchanger.
Cleaning and maintenance
TECNIKA 28-35
USE AND INSTALLATION MANUAL
Extract the turbolators (upwards). Practical
experience demonstrates that these elements
may be
Consequently, they must be lifted vertically with
care.
Figure 8.1.6 Lift the turbolators to extract them
from the convective heat exchanger of the boiler
Start-up fin
Turbolators, installed
for intensifying the
heat
process
jammed by deposits
Technical dept. - All rights reserved - Reproduction prohibited
Chapter
8
page 50
exchange
of ashes.