RED TECNIKA 28 Use And Installation Manual page 49

red
Clean the convective ducting of the boiler as follows:
loosen the special fastening nuts used for tightening the lid of the convective ducting of the boiler and
carefully remove the lid. Practical experience shows that in some cases, the seal may not adhere to the
convective section plates making it difficult to remove the lids. Be careful not to damage the seal bead and
replace it if needed.
Figure 8.1.3 Upper opening convective lid for removing ash collected from heat exchange surfaces of the
boiler
Figure 8.1.4 Lower opening convective lid for removing ash deposits after cleaning the heat exchange
surfaces of the boiler
Cleaning and maintenance
TECNIKA 28-35
USE AND INSTALLATION MANUAL
Fastening nuts,
fixing the upper lid of the
convective ducting
Fastening nuts, used
for fixing the lower lid
of the
ducting
Technical dept. - All rights reserved - Reproduction prohibited
Chapter
8
page 49
used for
convective