15-Cleaning And Maintenance - RED COMPACT 35 Easy Clean Installation Manual

15-CLEANING AND MAINTENANCE

Disconnect the product from the 230V power supply before performing any maintenance operation.
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
If the pellets in the tank run out, unburned pellets may accumulate in the brazier; always remove these residues from the brazier.
Check the status of your brazier every 15 days.
The automatic cleaning system means you don't have to empty the brazier. However, if there are pellets with a very high ash residue this
system may not be enough.
We therefore recommend adjusting the checks to the kind of fuel you are using. MCZ recommends using A1 class pellets with an ash
residue of less than 0.7%.
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE SAFE IGNITION AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT. IN CASE OF FAILED IGNITION AND AFTER ANY OTHER LOCK STATE OF THE
PRODUCT, IT IS ESSENTIAL TO EMPTY THE BRAZIER BEFORE EVERY RESTART.
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom.
If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the component.
Otherwise, if there are stubborn deposits, use a steel tool to clear the holes.
Technical Dept. - All rights reserved - Reproduction is prohibited
63 63