12-MAINTENANCE AND CLEANING
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
BEFORE EACH START-UP
Using a suitable tool clean brazier "G" from ash and any incrustation which could obstruct the air passage holes. If the pellets in the hopper
finish, unburned pellets may accumulate in the brazier. Always empty the residue in the brazier before starting-up.
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE START-UP AND OPTIMAL
OPERATION OF YOUR PELLET BOILER.
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom.
If you use good quality pellets, you will normally only need to use a paintbrush to restore the perfect operating condition of the component.
For tough incrustations, use the steel tool provided with the boiler.
CHECKS TO BE PERFORMED EVERY 2/3 DAYS
Clean the compartment around the brazier from ash paying attention to hot ashes.
Only if the ash is completely cold can a vacuum cleaner be used to remove it. Use a drum-type vacuum cleaner that is suitable for
picking up particles of a certain size. Experience and the quality of the pellets will determine the cleaning frequency required.
However, it is recommended not to exceed 2 or 3 days.
46
CLEANING THE ASH COLLECTION COMPARTMENT