Example Program - High End Systems SolaHyBeam 2000 User Manual

Example Program

Run the auto program：A master fixture can output to three different program signals to the slave fixture to
operate. It means the host will send cyclically in the following orders (The host will keep operating the
program of Part 1), then the slave fixture will selectively receive according to its own set.
1． If the slave fixture chooses Run For Slave 1 from the menu of 1-3, then it will receive the part 1's
automatic program from link, in the same way, when the slave fixture chooses Run For Slave 2,
then it will receive the part 2's automatic program from link.
2． Enter the menu of 1-3 Function Mode---Set To Slave, Here to set machine operate which part of
the program during the host-slave connection
3． Enter the menu of 1-4,1-5 Function Mode---Set To Master
4． Enter the menu of 8-1 Edit Program---Auto Program Part1.The host outputs three groups driven
program---Part1, Part2, Part3(Part1 program runs the same effect as the host)
5． Enter the menu of 8-2 Edit Program---Edit Program. Edit the program's connection, connect the
scene in order
6． The editor of the scene, there are as many as 250 scenario editors, and every scene can have a
program connection of 10.
Note:
Part 2, Part 3 repeat in accordance with the Part1's repeat. For example: When Part 1 uses
Program 2, Part 2 uses Program 4, Part 3 uses Program 6, Assume: Program 2 includes scene
of 10, 11, 12, 13; Program 4 includes scene of 8, 9, 10; Program 6 includes scene of 12, 13, 14,
15; Then it will run as below.
Example：
SolaHyBeam 2000 User Manual
35
v1.3