Example Of Using Manual Control - High End Systems Power Cue Store User Manual

Example of Using Manual Control

You can use manual control when, for example, DMX data is lost. In that case,
Power Cue Store outputs scene 00 before switching to manual control.
An example of manual control is shown below:
A step-by-step discussion of the example follows:
1.
2.
3.
4.
Press the AUTO button to advance to scene 01.
Do one of the following:
o
Press AUTO again to advance to the next valid scene. Fade times
are used but Hold times are ignored.
o
Use the slider to advance to the next valid scene, ignoring both Fade
and Hold times.
Enter a scene number in the display.
You can then use the AUTO button or the slider to advance to the desired
scene. Fade and Hold times function as discussed in Step 2.
Deleted or unprogrammed scenes are ignored. There is no effect on the
outputs, nor on Fade and Hold times.
When the designated start-of-chase scene (SoC) is encountered, Power Cue
Store steps automatically through the chase, using programmed Fade and
Hold times until one of the following occurs:
o
An end-of-chase scene (End) is encountered, at which time the
chase starts over with the start-of-chase scene (SoC).
Power Cue Store
TM
User Manual Page 11