Safety Instructions; Important Safety Warning - High End Systems SolaHyBeam 2000 User Manual

SAFETY INSTRUCTIONS

IMPORTANT SAFETY WARNING

This device has left the factory in perfect condition. In order to maintain this condition and to ensure safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written
in this user manual.
In order to install, operate, and maintain the lighting fixture safely and correctly we suggest that the
installation and operation be carried out by qualified technicians and these instructions be carefully
followed.
HIGH VOLTAGE. RISK OF SEVERE OR FATAL ELECTRIC SHOCK
ALWAYS DISCONNECT MAINS SUPPLY BEFORE REMOVING ANY
FIXTURE COVERS
NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE. SENSITIVE PERSONS
MAY SUFFER AN EPILEPTIC SHOCK
NEVER TOUCH THE DEVICE DURING OPERATION! COVERS MAY BE HOT
KEEP THIS DEVICE AWAY FROM RAIN AND MOISTURE
Important:
Damage caused by the disregard of this user manual is not subject to warranty. The
dealer and manufacturer will not accept liability for any resulting defects or
problems.
•
If the device has been exposed to temperature changes due to environmental conditions, do not
power on immediately. The resulting condensation could damage the device. Leave the device
powered off until it has reached room temperature.
•
This device falls under protection-class I. Therefore, it is essential that the device be earthed.
•
If either lenses or display are damaged (damage may include cracks or gashes in the material)
they must be replaced.
•
Electrical connections, such as replacing the power plug, must be performed by a qualified person.
•
Make sure that the available voltage is not higher than that which is stated at the end of this
manual.
•
Make sure the power cord is never crushed or damaged by sharp edges. Should the power cord
suffer, replacement of the cable must be done by an authorized dealer.
•
If the external flexible power cord of this device is damaged, it shall be exclusively replaced by the
manufacturer or their service agent or a similar qualified person in order to avoid injury.
•
When the device is not in use or before performing maintenance, always disconnect the device
from the mains. Only handle the power cord from the plug. Never pull the plug out of a socket by
tugging the power cord.
•
When powered on for the first time, some smoke or smell may occur. This is caused by coating on
SolaHyBeam 2000 User Manual
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
12
v1.3