Specifications; Installation Instructions - Altronix R2416UL Installation Manual

These Altronix Rack Mount CCTV Power Supplies provide 24VAC or 28VAC distributed via sixteen (16) fuse or
PTC protected outputs for powering CCTV Cameras, heaters and other video accessories.
Sixteen (16) Output Rack Mount Configuration Reference Chart:
Altronix
Model Number
24VAC
R2416UL
28VAC
24VAC
R2416ULCB
28VAC
24VAC 12.5 amp
R2416300UL
28VAC
24VAC 12.5 amp
R2416300ULCB
28VAC
24VAC
R2416600UL*
28VAC
24VAC
R2416600ULCB
28VAC
*24VAC models: Outputs 1-8 provide 12.5 amp (300VA) max. Outputs 9-16 provide 12.5 amp (300VA) max.
*28VAC models: Outputs 1-8 provide 10 amp (280VA) max. Outputs 9-16 provide 10 amp (280VA) max.
• UL Listed for Commercial CCTV Equipment (UL 2044). • Sixteen (16) individual power LED indicators.
CUL Listed - CSA Standard C22.2 No. 1-98, Audio,
Video and Similar Equipment.
• 24VAC or 28VAC (Factory set @ 24VAC).
• Illuminated power disconnect circuit breaker
with manual reset
• Surge suppression.
1. Mount unit in desired rack location (Space unit at least 3" from any video monitors), Do not obstruct side air vents.
2. Set power disconnect circuit breaker to OFF position (Fig. 1d, pg. 3).
3. The unit is factory set for 24VAC operation.
For 28VAC operation, adjust unit prior to mounting and applying power as follows:
a. Open bottom of unit by removing six (6) screws (Rack Mechanical Drawing & Dimensions, pg. 4).
b. For 28VAC operation, adjust unit prior to mounting and applying power as follows:
Change the wire position so that the black wire [28V] is connected to the terminal marked [P] and
the yellow wire [24V] is connected to the terminal marked [S].
c. After securing all wires for proper voltage place bottom panel back on the unit and fasten with the six (6) screws.
Note: R2416ULCB set for 28VAC operation is not Class 2 Rated, not power limited.
4. Plug power cord into grounded 115VAC 50/60 Hz receptacle (Fig. 1c, pg. 3), ground should be connected
as indicated in (Fig. 1e, pg. 3).
- 2 -
Overview:
7 amp
16
6 amp
7 amp
16 Yes
6 amp
16
10 amp
16 Yes
10 amp
25 amp
16
20 amp
25 amp
16 Yes
20 amp

Specifications:

Installation Instructions:

Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
3.5 3.5 amp/
Yes 3.5 amp
amp
3.5 amp/
2.5 amp
3.5
Yes 3.5 amp
amp
2.5 amp
3.5
Yes 3.5 amp
amp
2.5 amp
• Removable terminal blocks with locking screw flange.
• Unit maintains camera synchronization.
• Ease of installation saves time and eliminates costly labor.
• 2U rack mount chassis for use in standard EIA 19" rack.
Rack Dimensions:
3.25"H x 19.125"W x 8.5"D
2.9 amp
250V
2.9 amp
250V
3 amp
3 amp
6 amp
6 amp
R2416ULseries