Motorola recommends the following process for entering AES link encryption configuration:-
1. Open two browsers, one for each end of the link
2. Navigate to the 'Configuration' data entry page for each end of the link
3. At both ends of the link select the 'AES (Rijndael)' Encryption Algorithm required.
4. At both ends of the link enter ether an 128-bit or 256-bit encryption key. Note the key consists
of 32/64 case insensitive hexadecimal characters. The same Key must be entered at both ends
of the link. Failure to enter the same key will cause the link to fail.
AES Encryption Upgrade
Figure 127 AES Configuration Data Entry Page
174