Remote Management Page - Motorola MOTOWI 4 User Manual

8.3.10 Remote Management Page

The Remote Management page
remote management of the PTP 500 Series Bridge.
8.3.10.1 Control Access to HTTP Interface
The attribute HTTP Access Enabled allows a user to stop any access to a unit via the web
interface. The default value for this control is set to "yes", which means that the unit can be
accessed using the web interface. If the option "No" is selected, then a warning is displayed as
shown in Figure
8.3.10.2 Control Access to Telnet Interface
The attribute HTTP Telnet Enabled allows a user to stop any access to a unit via the telnet
interface. The default value for this control is set to "yes", which means that the unit can be
accessed using the telnet interface
8.3.10.3 SNMP (Simple Network Management Protocol)
The industry standard remote management technique is SNMP (Simple Network Management
Protocol). The PTP 500 Series Bridge supports version 1 and version 2c of the SNMP protocol.
8.3.10.4 Supported Management Information Bases (MIBS)
The PTP 500 Series Bridge SNMP stack currently supports the following MIBs:
MIB-II, RFC-1213, The PTP 500 Series Bridge supports the 'System Group' and 'Interfaces
Group'.
Bridge MIB, RFC-1493, The PTP 500 Series Bridge supports the 'dot1dBase Group' and the
'dot1dBasePortTable Group'.
PTP 500 Series Bridge proprietary MIB
RFC-2233 (High capacity counter) MIB
WiMAX MIB SNMP TRAPs supported:
Cold Start
Link Up
Link Down
DFS Channel Change
DFS Impulsive Interference
20
Note that if HTTP, Telnet and SNMP interfaces have been disabled, then the user needs to use the Recovery image
to Şreset IP & Ethernet Configuration back to factory defaultsŤ to re-enable the HTTP-Telnet interfaces. SNMP
can also be used to re-enable the other interfaces if SNMP is enabled.
Web Page Reference
(Figure
69.
20
68) allows the system administrator to configure the
111