Error Code Chart - Frigidaire GLTF2940ES0 Datasheet

Error code
E11 Fill time too long.
E13 Water leak in tub or air leak in air bell.
E14 Reed switch.
E21 Water not pumping out fast enough.
E23 Drain pump relay on control board failed.
E24 Drain pump relay on control board failed.
E31 Better models. Pressure sensor not communicating
with control board.
E35 Better models. Pressure sensor indicates water overfill.
E41 Control board thinks the door switch is open.
E42 Door remains locked after cycle is completed.
E43 Control board problem.
E44 Control board problem.
E45 Control board problem.
E46 Control board problem.
E47 Board thinks the door PTC circuit is open in spin.
E48 Board thinks the door PTC circuit is closed.
E52 Bad signal from tacho generator.
E55 Motor overheating.
E56 High motor current.
E57 High current on inverter.
E58 High current on motor phase.
E59 No tacho signal for 3 seconds.
E5A High temperature on heat sink.
E5B High temperature on heat sink.
E5C High temperature on heat sink.
E5D Communication problem.
E5E Communication problem.
E5F Communication problem.
E67 Input voltage on microprocessor incorrect.
E75 Better models only. Water temperature sensor circuit.
E76 Better model only. NTC temperature for the cold water
valve over the limits.
E95 Communication error.
EB1 Incoming power frequency out of limits.
EB2 Incoming line voltage above 130 VAC.
EB3 Incoming line voltage below 90 VAC.
EF1 Clogged drain pump.
EF2 To much soap.

Error code chart

Fault condition
3
Check
Refer to test (1).
Refer to test (2).
Refer to test (3).
Refer to test (4).
Replace control board.
Replace control board.
Refer to test (5).
Refer to test (6).
Refer to test (7).
Refer to test (8).
Replace the control board.
Replace the control board.
Replace the control board.
Replace the control board.
Refer to test (9)
Refer to test (9)
Refer to test (10)
Refer to test (11)
Refer to test (11)
Refer to test (11)
Refer to test (11)
Refer to test (12)
Replace the speed control
board.
Replace the speed control
board.
Replace the speed control
board.
Refer to test (13)
Refer to test (13)
Refer to test (13)
Replace the control board.
Refer to test (14)
Hot and cold water hoses
switched.
Replace the control board.
Refer to test (15)
Check voltage at the outlet. If
below 130 VAC, replace the
control board.
Check voltage at the outlet. If
above 90 VAC, replace the
control board.
Unclog the drain pump.
Advise customer to reduce
the amount of soap they are
using.
P/N 134408500