Disconnecting Supply Lines; Storing The Washer (Frost-Protected) - Nilfisk-Advance MC 2C-180 PE Instructions For Use Manual

MC DE, MC PE, MC PE PLUS
Switching off MC DE
5.2 Disconnecting supply
lines
5.3 Storing the washer
(frost-protected)
10
1. Shut the fuel cock.
2. Remove the water hose from
the washer.
1. Store the pressure washer in
a dry room without danger of
frost.

IMPORTANT!
If the high-pressure washer
is stored in a room with
temperatures around or
below 0°C, anti-freeze should
be drawn into the pump
beforehand:
1. Remove the water inlet hose
from the washer.
2. Remove the lance.
3. Start the washer and stop it
again after max. one minute.
1. Stop the washer by moving
the throttle lever to STOP
position.
2. Switch off the ignition by
pushing the ON/OFF button.
The light indicators will now
turn off.
4. Connect the suction hose
to the water inlet of the
washer and place it in a tank
containing anti-freeze.
5. Start the washer.
6. Hold the spray gun over the
tank containing anti-freeze
and activate it to start suction
of anti-freeze.
7. During suction operate the
spray gun two or three times.
8. Lift the suction hose from the
tank containing anti-freeze
and activate the spray gun to
pump out the remaining anti-
freeze.
9. Stop the washer.
Original Instructions