Table of Contents
Advertisement
MC DE, MC PE, MC PE PLUS
4.2.2 Switching on the
washer when it is
connected to open
tanks (suction mode)
4.2.3 Start machine
Start MC PE with electric starter
Start MC DE
8
1. Before connecting the suction
hose to the washer, fi ll the
hose with water.
2. Start the washer.
3. Unlock the spray gun and
activate it.
4. When using this machine in
suction mode, fi rst ensure
that the system has been
bled of air by letting the
machine run without high
pressure hose and spray
lance mounted until all air
has escaped. On some
models you need to kink
1. Switch on the ignition by
pushing the ON/OFF button
of the machine. The charging
the by-pass hose and / or
move the engine throttle to
minimum position to achieve
enough suction power.
During work breaks of more
than three minutes, switch off
the washer.
NOTE!
For automatic
suction from a tank, watercourse
or similar sup ply, the inlet hose
must be fi lled with water before
you start. The suction height
depends on the water tempe-
rature. Max. suction height (see
section 8.3 Technical Data) is
reached with cold water (up to
8°C). With 60°C warm water, the
ma chine must be under or at the
water level.
If the water being suctioned
contains particles, a suction
fi lter must be mounted on the
end of the hose.
In case of risk of running sands,
a sand fi lter must be attached.
1. Start the engine by turning
the key (see the operating
instructions for the engine.
2. Check that the throttle lever
is adjusted correctly - need to
be in Run position.
+ oil light indicators will turn
on.
2. Move the throttle lever to
SLOW or RUN position.
3. Push the start button until
the machine starts. Now the
charging + oil light indicators
will turn off. If not, stop
the machine immediately
and contact Nilfi sk service
department.
4. The machine can be started
by means of the starter rope
if the battery has gone fl at.
See manual from Yanmar.
Original Instructions
Advertisement
Table of Contents
