After Using The Cleaner; Switching Off The Cleaner; Disconnecting Supply Lines; Rolling Up The Electrical Lead And Storing Accessories - Nilfisk-Advance MH 7P Instructions For Use Manual

english

6 After using the cleaner

6.1 Switching off the
cleaner
6.2 Disconnecting supply
lines
6.3 Rolling up the electrical
lead and storing
accessories
6.4 Storing the cleaner
(below 0°C (32°F))
12
1. Turn the main switch to posi-
tion „OFF".
2. Turn off water supply at faucet.
3. Squeeze the spray gun trigger
until the pressure has bled off.
4. Slide trigger lock to the locked
position.
Store the cleaner in a dry heated
location to protect against freez-
ing or protect per below instruc-
tions:
1. Remove the water supply
hose from the cleaner.
2. Remove the spray lance.
3. Switch on the cleaner with the
main switch in position
A
4. Squeeze trigger of the spray
gun.
5. Gradually pour antifreeze (ap-
prox. 5 litres) into the water
tank (A).
6. While the pump is pulling the
mixture from the water tank,
0
I
M
1. Turn the main switch to posi-
tion „OFF".
2. Turn off water supply at faucet.
3. Squeeze the spray gun trigger
until the pressure has bled off.
4. Slide trigger lock to the locked
position.
5. Remove the water supply
hose from the cleaner.
6. Remove power cord plug from
the electrical supply.
Risk of tripping!
To prevent accidents, always
carefully roll up the power cord.
Machines with hose and/or cord
reel:
1. Wind up the power cord as il-
lustrated with the plug located
in the center of the cord reel.
2. Wind up the high pressure
hose as illustrated.
3. Place the spray lance into the
spray lance storage.
squeeze and release the trig-
ger two or three times.
7. The machine is protected
against freezing when anti-
freeze mixture emerges from
the spray gun.
8. Lock the safety catch on the
spray gun.
9. Switch off the cleaner.
10. To avoid any possible dam-
.
age, store the cleaner tempo-
rarily in a heated room before
using it again.
11. When the machine is put into
service again, the antifreeze
solution can be collected and
stored for future use.
1) Options / model variants
Original instruction