Removal - NEC Express5800/B120e-h User Manual

Chapter 2 Preparations
8. Run SETUP and select menus in the order of Advanced and Memory Configuration to make sure
that the status of installed DIMM is "Normal" (refer to Chapter 2(1. System BIOS) in "Maintenance
Guide".).
9. Set the paging file size to a value larger than the recommended value (installed memory * 1.5) (for
Windows). Refer to Installation Guide for more information.

1.5.3 Removal

To remove DIMMs, remove the top cover and air duct according to Chapter 2 (1.3.1 Removal of top cover) and
(1.3.2 Removal of air duct), and then perform steps in Chapter 2 (1.5.2 Installation) in reverse order.
After DIMMs were removed, make sure that no error message appears in POST.
If any error messages are displayed, refer to Chapter 3 (1. POST Error Message) in "Maintenance Guide".
Run SETUP and select Yes after selecting Advanced → Memory Configuration → Memory Retest. Restart
the CPU blade to clear the error information of the removed DIMM (refer to Chapter 2 (1. System BIOS) in
"Maintenance Guide".).
Set the paging file size to a value larger than the recommended value (installed memory * 1.5) (for Windows).
Refer to the Installation Guide for more information.
To remove the defected DIMM, check the error message appearing in POST or NEC
Note
ESMPRO to confirm the CPU blade on which the detected DIMM is installed.
Express5800/B120e-h User's Guide
1. Installing Internal Optional Devices
53