NEC Express5800/B120e-h User Manual page 64

Chapter 2 Preparations
(1)
Procedure 1
1. Shutdown the CPU blade system and turn off the power of the CPU blade.
2. Replace the Solid State Drive.
3. Set up the system again.
(2)
Procedure 2
1. Delete all the volumes and partitions on the Solid State Drive to be removed.
To delete volumes and partitions, select Programs → Administrative Tool → Computer
Management → Disk Management from the Start menu.
Select Delete volume / Delete partition from the menu appearing by right-clicking on
Volume/Partition.
2. Shutdown the CPU blade system and turn off the power of the CPU blade.
3. Remove the Solid State Drive.
4. Install the new Solid State Drive.
5. Turn on the power of the CPU blade.
6. Delete the removed disk.
To delete the disk, select Program → Administrative Tool → Computer Management → Disk
Management from the Start menu.
Right-click the removed disk in the Disk Management menu to select Delete disk.
7. Import the installed Solid State Drive.
To import the disk, select Program → Administrative Tool → Computer Management → Disk
Management from the Start menu.
The installed drive has a different format. Right-click on the installed drive and select Import disk of
different format.
8. If NEC ESMPRO Agent is used, reset the Solid State Drive (refer to Chapter 2 (1.7.4 Resetting
Management Information).
64
Important Because the data cannot be recovered in this procedure, take the proper action
such as data backup if necessary.
•
Important Delete volumes and partitions carefully. Pay attention not to delete volumes
and partitions from a normal disk.
•
The volume and partition deletion disables the data to be recovered. Take the
proper action such as data backup if necessary.
Express5800/B120e-h User's Guide
1. Installing Internal Optional Devices