Device Identification - NEC Express5800/B120e-h User Manual

Chapter 3 Setup
6.

Device Identification

To identify the device to be maintained among more than one device, ID lamp is used.
The ID lamp is located on the CPU blade installed in the Blade Enclosure.
The ID lamp allows you to identify the device subject to maintenance among more than one CPU blade
installed in the Blade Enclosure.
The ID lamp on CPU blade can be made lit blue by proper software commands (NEC ESMPRO Manager) from
the management PC on the network or by pressing the ID switch on the CPU blade.
You may use the remote control feature of EXPRESSSCOPE Engine 3 (BMC) to perform the same operation
as using the ID switch on the CPU blade.
ID switch
DMP
1
RST
2
ID
ID lamp
Express5800/B120e-h User's Guide
6. Device Identification
101