Table of Contents
Advertisement
COLLECTION
Fault
Possible
cause
The auger
Collection
is not
unactivated.
activated
when the
cutting
Blown fuse.
deck is
lowered.
Lift lever
switch.
Solenoid
clutch.
Wiring fault.
Auger control
switch.
The
Safety switch
product
not activated.
beeps (3
Hz) when
Wiring fault.
the cutting
deck is
lowered.
The
The auger
product
does not
beeps
rotate.
constantly
Rotation
when the
Sensor does
cutting is
not work.
lowered.
Wiring fault.
Lift lever
switch.
Steps
Troubleshooting
1
Make sure that the auger control switch turns
green.
2
Measure the voltage on J6 (pin 3) with the key in
"ON" position. The voltage should be equal to the
battery voltage.
3
Check that the microswitch changes the position
when the lift lever is lifted.
4
Measure the resistance between the pins of the
solenoid clutch. The resistance should be about
3 ohms at room temperature.
5
Measure the resistance between Pin 7 of
connector to Auger Control switch and the red
cable into the connector for solenoid clutch. The
resistance should be close to 0 ohms.
6
Measure the resistance between the grounding
point and the black cable connector for solenoid
clutch. The resistance should be close to 0 ohms.
7
Disconnect the front harness connector.
Measure the resistance between pin 7 of the
connector to the auger control switch and Pin 1
front harness connector. The resistance should
be close to 0 ohms.
8
Disconnect the front harness connector.
Measure the resistance between the grounding
point and Pin 2 of the front harness connector.
The resistance should be close to 0 ohms.
9
Measure the voltage of the auger control switch
when the lift lever is lowered.
10
Examine the switch indicated on the panel.
11
Check the wiring from the Auger control unit to
the respective safety switch.
12
Check that the screw can rotate freely.
13
Check that the sensor is close enough (about 1
mm) pulley and the signal is pulsed when the
holes passing through the sensor.
14
Check the wiring from the Auger control switch
for the rotation sensor.
15
Check the switch.
Appendices and schedules
Action
Press the button until
the color changes
and a short beep is
heard.
Replace fuse.
Replace the micro
switch.
Repair the solenoid
clutch.
Go to step 7.
Go to step 8.
If the resistance is
low, replace the front
frame harness. If the
resistance is low
change the auger
control harness.
If the resistance is
low, replace the front
frame harness. If the
resistance is low
change the auger
control harness.
Replace the auger
control switch.
Replace the switch.
Repair the cable or
replace the cabling.
Reposition / replace
sensor.
Repair the cable or
replace the cabling.
Go to step 3.
English – 81
Advertisement
Table of Contents
