Table of Contents
Advertisement
11. Put the drive belt around the tension wheel (2).
Make sure that the drive belt runs as illustrated.
2
12. Put the spring in the spring holder (3)
13. Set the lift lever for the cutting deck in locked
position. The cutting deck lifts.
14. Pull the auger service position lever to up
position.
15. Snap on the front cover.
Remove the cutting deck
1. Do steps 1-6 In attach the cutting deck.
2. Pull the spring handle to the right out from the
spring holder to loosen the tension on the drive
belt tension wheel (1)
3. Hold the spring handle with your left hand and lift
off the drive belt with your right hand.
4. Pull the drive belt to the rear under the product.
5. Put the spring handle in the spring holder so that
1
6. Lift the cutting height stay and put in the stay
3
7. Grip the front edge of the cutting deck with both
8. Lift the service lock to vertical position.
of the cutting deck with both hands when you
continue to the next step.
9. Lift the front edge of the cutting deck until the
Do not put it in the belt holder (2).
the spring does not fall down
holder (3).
2
hands and pull forwards until it stops.
WARNING: Fingers can get seriously
injured in the lock mechanism. To
prevent injury, put the service lock in full
vertical position and hold the front edge
service lock rests against the frame and pull the
cutting deck out.
Cutting system
3
1
English – 57
Advertisement
Table of Contents
