Pic Test Error Codes; Pic Test Section 1; Pic Test Section 3 - HP MICRO 3000 Diagnostic Manual

Error Codes
PIC TEST ERROR CODES
If
the PIC test fails, the slot test will display one of the following error codes. The tests are run
in
the
same sequence as the test sections. Testing stops when the first failure is detected.
PIC Test Section 1
This section is the initialization test whidl initializes the PIC and verifies regi!;ters contain expected data.
Code Error
0104 Register
4
initialization error (expected
SOOOO)
0105 Register
5
initialization error (expected
SOOOO)
0106 Register
6
initializa tion error (expected
$0020)
0107
Register
7
initialization error (expected
SOOnG)
0108 Register
8
initializa tion error (expected
$0000)
010A Register A initialization error (expected
$0000)
010C Register C initiallza tion error (expect.ed $0000)
010f Register F initialization error (expected
$0087+(8 t
channelH»
PIC Test Section 2
This sedion tests basic operations and 0811, IPOLl, SMSK and RMSK.
Code Error
0201 St'tlSK/RMSK test; PIC did not respond with mask bit set.
0202 SMSK/RMSK test; PIC did not respond with mask bit cleared.
0203
PIC did not set IRQ after SMSK on selected channel.
0204 Improper IPOtl. response after SMSK (no response,
wrong response, or multiple channels responding).
0205 Improper OBII data from this channel after SMSK.
0206 Improper register D response after SMSK.
0207 Improper IPOll response (should have been clear).
0208 Received no CSRQ after issuing a SlOP.
0209 \Vrong channel is responding to SPOlL.
020A Improper CBS! data after SPOLL
0208
Improper register F data after SPOlL.
020C Improper CSRQ response after IIIOP (should have been zero).
0200 Improper SPOLl after IIIOP (should have been zero).
020E Improper 08SI response to SPOLL after IHOP
(should have pointed to device 7).
DEC 86