Tcp/Ip Configuration For Macos X - Arris Touchstone TG1652 User Manual

1. Open the Windows Control Panel.
2. Click
Network and Internet
3. Click
Network and Sharing Center
4. Click
Local Area Connection
5. Click
Properties
6. Select
Internet Protocol Version 4 (TCP/IPv4)
Note: If your cable provider requires TCP/IP version 6, select
and click
The TCP/IP properties window for the version you selected displays.
7. For either TCP/IPv4 or TCP/IPv6, select
server address automatically
8. Click
OK
back out of the remaining setup screens.

TCP/IP Configuration for MacOS X

Follow these steps to configure the Ethernet interface on a MacOS X operating system.
1. Open System Preferences, either by choosing
by clicking the System Preferences icon in the dock.
2. Click the
3. Choose
menu.
4. Choose the TCP/IP tab, if necessary.
If you are using
If your cable provider requires
5. Choose
6. If necessary, click the
7. Close the System Properties application.
TCP/IPv4 configuration is completed.
8. If you are using TCP/IPv6, click
9. Choose
10. Close the System Properties application.
Release 16 STANDARD 1.2 August 2015
Copyright ARRIS Enterprises, Inc. 2015. All Rights Reserved.
.
.
to open the Status window.
to open the Properties window.
Properties
to configure TCP/IPv6.
, unless instructed otherwise by your cable provider.
to accept the new settings and close the Properties window. Then click
icon.
Network
from the Location drop-down menu, and
Automatic
, go to step 5.
TCP/IPv4
from the Configure IPv4 menu.
Using DHCP
Renew DHCP Lease
from the Configure IPv6 drop-down menu and click
Automatically
Chapter 5: Configuring Your Ethernet Connection
and click
Properties
Obtain an IP address automatically
System Preferences
, go to step 8.
TCP/IPv6
button.
near the bottom of the previous window.
Configure IPv6
Touchstone TG1652 Telephony Gateway User Guide
to configure TCP/IPv4.
Internet Protocol Version 6 (TCP/IPv6)
and
Obtain DNS
from the Apple menu or
from the Show
Built-in Ethernet
.
OK
to
Close
31