Table of Contents
Advertisement
6.3.3
Interface Card
The camera must connect to an interface card. This is sometimes called a host adapter, a bus controller, or a
network interface card (NIC).
A 10G BASE-T NIC is recommended for streaming images on the Ethernet network between the camera and host
system.
FLIR sells a compatible card (PN: ACC-01-1101) available from our
6.3.4
General Purpose Input/Output (GPIO)
The camera has an 12-pin GPIO connector on the back of the case; refer to the diagram below for wire color-
coding.
Color
Black
White
Green
Orange
Blue
White with black
stripes
Red with black
stripes
Green with black
10/27/2017
©2017 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Note: For optimal ESD protection, we recommend using a
shielded Ethernet cable or connecting the camera housing to
chassis ground (earth).
Pin
Line
Function
1
N/A
GND
2
N/A
POWER
Line
Red
3
GPIO_OPT_OUT1
1
Line
4
GPIO_OPT_OUT2
4
Line
5
GPIO_OPT_IN1
0
Line
6
GPIO_OPT_IN2
3
Line
7
GPIO_TTL_IO3
2
Line
8
GPIO_TTL_IO4
5
9
N/A
GND
Products Accessories
DC camera power ground
Opto-isolated output (GPO1)
Opto-isolated output (GPO2)
Opto-isolated input (GPI1)
Opto-isolated input (GPI2)
DC camera power ground
®
FLIR Oryx
Installation Guide
6 Oryx Physical Interface
page.
Description
DC camera power
TTL input/output 3
TTL input/output 4
17
Advertisement
Table of Contents
