PRINT CARE AND CLEANING GUIDE
■
Fill the VAT with water and let it sit for 10-15 mins to test for leaks.
■
Replace the VAT if there are any cracks or leaks.
■
Clean the VAT after printing an object.
■
Do not leave the resin inside the VAT when not in use or printing.
■
Do not expose the VAT to excessive heat or direct sunlight.
■
Ensure not to scratch the lens of the projector.
5. Rinse the VAT with clean water.
6. Wipe the VAT with a paper towel.
CLEANING THE PROJECTOR
1. Power down the printer.
2. Use a blower on a low power to remove dust.
3. Apply lens cleaning solution to a microfiber cloth.
4. Gently wipe the lens in a circular motion.
CLEANING THE T-1000
1. Power down the printer.
2. Apply a stain remover to a clean cloth.
3. Wipe the surface of the printer to remove splash or splatter of resin.
51
T-1000