Page 1
T-1000 QUICK START GUIDE This quick start guide explains basic instructions on how to unbox and set up the T-1000 3D printer. For more information, please refer to the T-1000 manual, available for download at g3dsys.com. COMPONENTS Head Stopper Calibration Lever...
Page 2
REMOVE THE ACCESSORY BOX TILT THE T-1000 BOX Slightly tilt the T-1000 box. Make sure to hold or lean the T-1000 box against a wall to prevent from falling. TRIM THE BOTTOM TAPED EDGES OPEN THE BOTTOM FLAPS Unfold the bottom flaps of the T-1000 box.
Page 3
UNBOXING ANG SETTING UP THE T-1000 REMOVE THE ACCESSORY FOAM SUPPORT LIFT THE T-1000 BOX Remove the plastic cover of the T-1000. LIFT THE T-1000 3D PRINTER Printer can be heavy for one person. 2 person lift can be optional. Use the side handles of the printer to separate the printer from the bottom foam support.
Page 4
UNBOXING ANG SETTING UP THE T-1000 UNTIGHTEN THE VAT STOPPERS Rotate the (4) four vat stoppers counter clockwise VAT INSERT to loosen, no need to remove the vat stoppers from the VAT insert. INSERT THE VAT TIGHTEN THE VAT STOPPERS Tighten the (4) four VAT stoppers only enough to snug them against the VAT.