Calibrating The Vat - G3D T-1000 Manual

PRINTING OBJECTS WITH G3D WEB UI

CALIBRATING THE VAT

Calibrating the VAT has similar procedures with positioning the build plate, only
this time you need to include the adjustment of calibration levers. It is important to
calibrate the VAT after a failed print or when you need to replace the VAT.
See "Removing the VAT" on page 46 to replace a VAT.
See "Setting the VAT" on page 9 to replace a VAT.
1. Lightly loosen all (4) four VAT stoppers. Rotate the VAT stoppers counter
clockwise.
2. Untighten all (4) four calibration levers.
LEFT VAT SIDE VIEW
3. Gently push down the walls of VAT to check if the calibration levers are in
unlocked position.
T-1000
2
1
2
1
VAT STOPPER
3
4
3
4
RIGHT VAT SIDE VIEW
24